Plasma Cutters

Back to Welding and Cutting Machines

The CEMONT range of plasma cutters allows the user to cut all kinds of conductive materials from 0.5 to 40mm depending on the machine.

These machines are equipped with pilot arc, thermal protection and air pressure control. Each comes complete with a 6-meter torch, ground cable with clamp, mains power cable, air pressure regulator with gauge and moisture separator.

Below is the CEMONT range of cutting machines offered by Telford group.

Sharp 6K - 240 Volt

6mm Max Cut

Plasma Cutter with Built in Air Supply 6mm Max Cut Capacity. Portable and lightweight (12kg) inverter based plasma cutter with built in compressor. High quality cutting on all conductive materials including steel, stainless steel, aluminium, copper, brass, etc.Operated from 16 amp single phase supply. Able to cut gratings and thin
galvanised steel. 2 Year Warranty

Sharp 10 - 240 Volt

10mm Max Cut

Portable inverter for compressed air plasma cutting. High quality cutting on all conductive materials Thermal protection. Safety system for incorrectly assembled torch and for insufficient air pressure. Digital control of air pressure with condensate filter. Possibility of cutting gratings with automatic re-ignition of the pilot arc. 8 bar pressure required. 240 volt 16amp single phase. 2 Year Warranty

Sharp 22 - 415 Volt

20mm Max. Cut

Heavy duty three phase portable compressed air plasma cutting machine, for general purpose use. Features include, torch safety circuit, able to gouge, auto restarting for cutting grids and a high duty cycle of 65amps at 40% at 40oC, 25kg in weight. This machine is ideal for high quality cutting on most materials. 24mm severence, 20mm quality cutting thickness, 5.0bar compressed air pressure required, 180 l/mm air flow, 415 volt 3 phase.

Sharp 25M- 415 Volt

20mm Max. Cut

Heavy duty three phase compressed air plasma cutting machine, for general purpose use. Features include, 2 power settings, torch safety circuit, and 6 mtr cutting torch,This machine is ideal for high quality cutting on most materials.3 cutting steps, 20mm Maximum cutting thickness, 5.0bar compressed air pressure required, 140 l/mm air flow,

Sharp 40M- 415 Volt

40mm Max. Cut

Heavy duty three phase compressed air plasma cutting machine, for general purpose use. Features include, torch safety circuit, and high duty cycle of 120amps at 50% at 40oC,This machine is ideal for high quality cutting on most materials. 4 cutting steps, 40mm severence, 35mm quality cut and 8mm percing cutting thickness, 5.5bar compressed air pressure required, 220 l/mm air flow, 415 volt 3 phase.


If you require any other machinery such as: Sawing machines / Metalworking / Power tools etc, please contact Telford Group on:

01952 290800 or click here to e-mail.

And our Machine Solutions Service will match your requirements to your application.

Back to Welding and Cutting Machines